VapeWholesaleHub  |  Wholesale supplier · Shenzhen, China
Tel / WeChat / WhatsApp: +86 13711127975  |  vape@0099933.xyz
Home  /  THC Vape  /  Sourcing THC Vape: buyer protection quick reference
THC vape products · former smokers

Sourcing THC Vape: buyer protection quick reference

There is no shortage of suppliers quoting THC vape. The scarce thing is a supplier who will tell you which SKU to drop. We have been shipping THC vape products long enough to know that the honest answer is usually a shorter list, and that is the answer we give.

Published 18 October 2025  ·  VapeWholesaleHub  ·  Reading time 5 min

Close inspection of the assembly line before the batch is released.
Close inspection of the assembly line before the batch is released.
Carton-ready units from the same batch, coded for traceability.
Carton-ready units from the same batch, coded for traceability.
Bulk packing station during the run for a former smokers order.
Bulk packing station during the run for a former smokers order.

What we test before a carton is sealed

We work with former smokers who order between a few hundred and a few thousand units at a time, and we treat both ends the same way: a written specification, a sample you approve, and a production run that matches the sample.

Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.

14 separate checks run before a carton is sealed: electrical, mechanical, leak, finish and packaging. Anything outside tolerance is quarantined the same day and reported to you, rather than shipped with a hope and a discount.

What your market will ask for

Age verification is not only a website problem. Retail packaging, shelf placement and staff scripting all carry compliance weight, and auditors increasingly ask for evidence of all three.

If you sell into a market that requires child-resistant packaging, say so at quotation stage. Retrofitting a CR closure onto a finished bottle design usually means a new mould and a four week delay.

For former smokers, the practical answer is usually a shorter range: two core lines, one step-up, one trial SKU. Everything else is inventory risk wearing a nice finish.

Lead times, freight and landed cost

Damage in transit is nearly always a packing decision, not bad luck. Double-walled cartons, internal dividers and a drop-tested configuration cost a little more and save the argument at the other end.

For repeat buyers we hold a shipping schedule rather than shipping on request. A fixed weekly cut-off means your reorder lands before the shelf empties instead of after.

  • Seven-day defect reporting with replace-or-credit
  • Document pack prepared per destination market
  • Cartons drop-tested and pallet-counted for clean freight
  • Named account contact who has handled the product
  • Mixed SKU cartons to spread first-order risk
  • Artwork proof plus physical dummy for custom packaging

How the price is actually built

Freight is quoted separately and honestly. Bundling it into the unit price looks tidy and hides the one line that changes most often between shipments.

Payment terms for new accounts are normally a deposit with the balance against the bill of lading. Established buyers on a repeat schedule can move to terms after three clean shipments.

Specification summary

Typical specification for this category
Volume0.5 ml
HardwareCeramic core
ThreadProprietary pod
AirflowFixed
WindowSide window
PackagingChild-resistant box
Minimum order50 units per SKU, mixed cartons allowed
Lead time12 working days after artwork approval

None of this is complicated. It is just written down, which is more than most buyers get before they wire a deposit.

Frequently asked

What happens if part of the order is defective?

Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.

Can we order samples before committing?

Yes. Sample orders are shipped by air express and the cost is credited against your first production order above 50 units. We would rather you handle the sample than approve a specification from a photograph.

What is the minimum order for THC vape?

Standard configurations start at 50 units per SKU, with mixed SKUs allowed inside the same carton. Custom colours, custom packaging or a private label run usually start at 200 units because of setup time on the line.

Related reading

Need a quotation on THC vape products?

Send destination market, target price and quantity. Same-day reply on working days.

Tel / WeChat / WhatsApp +86 13711127975  ·  vape@0099933.xyz

Talk to the supply team

Ask for a quotation on THC vape products

Tell us the market you sell into and the price band you work in. You will get a specification and a landed cost estimate, not a catalogue dump.

What to send

Destination market, target retail price, quantity per SKU, and whether you need private label. With those four lines we can quote the same day.

Samples ship by air express and the cost is credited against your first production order.

Email the team
WhatsApp Email us