THC Vape container load basics guide
If you are comparing three quotes for THC vape, compare the paperwork first. Test reports, artwork files, batch coding and the replacement clause tell you more about a supplier than the unit price on page one.
Published 21 August 2026 · VapeWholesaleHub · Reading time 8 min
Reading a quotation properly
Buyers come to us for THC vape after a bad quarter: dead stock on one side, empty shelves on the other. The cause is usually the same, an assortment built from a catalogue instead of from sell-through data. This page explains how we rebuild that balance for former smokers.
The cheapest way to lower your cost per unit is usually to remove a SKU, not to negotiate a discount. Fewer lines means larger runs, fewer changeovers and a better price at the same quality.
We publish a realistic band of 3.53 to 9.86 per unit for standard configurations at 500 units. Below that band you are buying a lighter specification; above it you are paying for finish, packaging or a smaller run.
Quality control, in plain terms
We photograph the packing station during production for volume orders. It is a small thing, but it settles most arguments about what was actually in the carton before it was sealed.
Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.
Building an assortment that actually turns
Sourcing trips still matter for volume buyers. Seeing the line, the ageing room and the packing station tells you in an hour what six emails cannot. We host visits by appointment and we do not stage them.
We source THC vape products from a small group of factories we have worked with for years. That means a specification can be held across repeat orders instead of being re-qualified from scratch every quarter. Consistency is a boring selling point and it is also the entire game.
- Private label files archived for future rebrands
- Standing reorder schedule with a fixed cut-off
- Specification locked in writing before production starts
- Document pack prepared per destination market
- Mixed SKU cartons to spread first-order risk
- Reference sample retained from every batch
Presentation that earns the step-up
Bundle a device with a consumable and the reorder rhythm changes from occasional to weekly. That single merchandising decision often does more for monthly revenue than a price promotion.
Shelf position decides velocity as much as price. Keep THC vape products at eye level, one facing per SKU, and rotate the trial line every quarter so the display keeps earning attention.
Specification summary
| Volume | 0.5 ml |
| Hardware | Ceramic core |
| Thread | Proprietary pod |
| Airflow | Fixed |
| Window | Full glass |
| Packaging | Tube |
| Minimum order | 100 units per SKU, mixed cartons allowed |
| Lead time | 22 working days after artwork approval |
None of this is complicated. It is just written down, which is more than most buyers get before they wire a deposit.
Frequently asked
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
What is the minimum order for THC vape?
Standard configurations start at 500 units per SKU, with mixed SKUs allowed inside the same carton. Custom colours, custom packaging or a private label run usually start at 1000 units because of setup time on the line.
Can we order samples before committing?
Yes. Sample orders are shipped by air express and the cost is credited against your first production order above 500 units. We would rather you handle the sample than approve a specification from a photograph.
Related reading
Need a quotation on THC vape products?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz